Ignore Text; Igp100 Compatibl; Intervention Req; Lac Approx - Printronix T5000 User Manual

Ignore Text

(From page 141.)
•
Disable. When disabled, text in Normal Mode will be printed. Attributes to
be printed depend on the PGL Normal menu setting.
•
Enable. When enabled, any line of text (non-PGL commands) in Normal
mode will be ignored.
The factory default is Disable.

IGP100 Compatibl.

(From page 141.) This parameter forces the output to correspond with IGP-
100 printer output in cases where there are differences.
The options are Disable (the factory default) and Enable.

Intervention Req

(From page 128, page 134.)
•
Send To Host. The printer sends a signal to the host computer when a
printer fault or hold mode time-out occurs.
•
Do Not Send. No signal will be sent to the host computer.
The factory default is Send To Host.
Italic Print
(From page 145, page 148, page 150, page 152, page 154.)
•
Disable. Text is printed normally.
•
Forward Slant. Text is printed with a forward slant.
•
Backward Slant. Text is printed with a backward slant.
The factory default is Disable.

LAC Approx.

(From page 131.) This submenu controls whether the LAC Approximation
(See your Coax/Twinax Programmer's Reference Manual) is used or not.
When set to On, then Approximation is used. When set to Off, Approximation
is not used, and incoming data will print as is.
The factory default is On.

LAC Option

(From page 131.) Allows the host system to load alternate character images
into the printer. This may be used for designing graphics, bar codes, and
charts, or for printing in foreign languages.
•
Enable. Prints the LAC character as defined.
181