Printronix T5000 User Manual page 261

Table 15. LCD Message Troubleshooting (continued)
Displayed Message
GRF CHK ERROR
PRESS PAUSE
Half Speed Mode
HEAD POWER FAIL
IGP/PGL ERROR
INSUFFICIENT RAM
Reboot/Add RAM
LOADING PROGRAM
FROM PORT XX%
LOADING PROGRAM
INTO FLASH
MENU MODE
VALIDATOR
Can User
Explanation
Correct?
Yes In the CT emulation over a
twinax interface, the printer
received a non-printable
character.
Yes The printhead is approaching
a hot state.
Yes/No Printhead lost power.
Yes Appears when the "Fault"
option is selected from Error
Report in the front panel.
Yes/No Not enough RAM memory
available for a printer
function.
Yes The new emulation program
is loading into printer RAM.
XX% indicates how much of
the program has loaded.
Yes A program is getting loaded
into flash.
Yes This is the normal message
that displays when you first
press the MENU key to place
the printer in Menu mode.
Fault Messages
Solution
Press the PAUSE key twice.
1. Allow the printer to continue
printing. Full speed will resume
automatically when a lower head
temperature is achieved.
2. Let the printer cool down. Full
speed will be restored when printing
is resumed.
1. Replace the printhead.
2. Power off the printer for 15
seconds, then power back on again.
If the problem persists, contact your
authorized customer service
representative.
Deselect "Fault" from Error Report on
the front control panel.
1. Power off the printer for 15
seconds, then power back on again.
2. To add more RAM memory to your
printer, contact your authorized
customer service representative.
No action required.
No action required.
No action required.
261