Host Override; Host Pi; I-2/5 Selection - Printronix T5000 User Manual

•
Disable. Sets the printer label size equal to the Label Length set in the
front panel under the PRINTER CONTROL menu.
The factory default is Enable.

Host Override

(From page 129, page 131, page 138.) Determines whether the printer
accepts certain commands sent by the host, or continues to use the current
operator panel settings.
•
Disable. Allows these host commands to override operator panel
settings: line length, forms length, lines per inch (LPI), characters per inch
(CPI), print quality, and text orientation. Note the information appearing on
the message display may not match the data stream setting. No values
will change upon initial selection of the disable option.
•
Enable. The operator panel settings override the host commands.
The factory default is Disable.

Host PI

(From page 144.)
•
Disable. The host does not send PI signals.
•
Enable. The host sends PI signals. The Data Bit 8 configuration option
must be disabled to transmit the PI line to the printer.
The factory default is Disable.

I-2/5 Selection

(From page 141.) This option is added to be compatible with a special IGP-
X00 customization. Usually, if Interleaved 2/5 bar codes have an odd number
of digits, a leading zero is inserted in front of the data. However, this special
IGP-X00 customization gives you the option of adding a space character at
the end of the bar code instead.
•
Leading Zero. A leading zero is inserted in front of the data.
•
Trailing Space. A space is inserted at the end of the data instead of a
leading zero.
•
X2 DPD. When selected, I-2/5 bar code with a magnification X2 will use
the specially configured ratios 3:3:6:5 rather than 3:6:9:12 for
compatibility issues.
•
Modulo 7 CD. The I-2/5 bar code uses a modulo 7 check digit instead of
the default modulo 10 check digit.
The factory default is Leading Zero.
Ignore Ch#1
(From page 143.) Specifies character 1 for the character filtering option. Valid
decimal values are from 0 through 255.
The factory default is 0.
179