Printronix T5000 User Manual page 285

. .
4. Press until "PRINTER CONTROL" displays.
.
5. Press ↑ until "Advanced User" displays.
6. Press + or - until "Enable" displays.
7. Press ↵ to select the "Enable" option. An asterisk (*) appears next to
"Enable."
. .
8. Press until "MEDIA CONTROL" displays.
.
9. Press ↓ until "Media Handling" displays.
10. Press + or - until "Cut" displays.
11. Press ↵ to select "Cut." An asterisk (*) displays next to "Cut."
12. Press ↓ until "Cutter Type" displays.
13. Press + or - until "Standard" displays.
14. Press ↵ to select "Standard." An asterisk (*) displays next to "Standard."
15. Relock the ↵ key by pressing ↓ and ↵ at the same time, then press
PAUSE to put the printer back online.
16. If the bar code validator is installed, adjust the validator beam. (Refer to
"VALIDATOR" on page 84.)
17. Make sure any media sticking out of the platen goes in the cutter entrance
slot.
18. Test the printer cutting operation and print quality by selecting the
Diagnostics → Printer Tests menu and printing one of the test patterns.
(Refer to "DIAGNOSTICS" on page 200.)
19. To save the configuration parameters, refer to "Saving A Configuration"
on page 72.
Restore The Printer To Operation
285