3Com 5500-SI Quick Reference Manual page 50

snmp-agent usm-user
Use the
snmp-agent usm-user
a new user to an SNMP group.
snmp-host
Use the
snmp-host
management device.
source-policy
Use the
source-policy
speed
Use the
speed
speed
Use the
speed
spf-schedule-interval
Using the
ssh client assign rsa-key
Use the
ssh client assign rsa-key
connected to guarantee the client can be connected to a reliable server.
ssh client first-time enable
Use the
ssh client first-time enable
ssh server authentication-retries
Use the
ssh server authentication-retries
connections.
ssh-server source-interface
Use the
ssh-server source-interface
specify a nonexistent interface in the command, your configuration fails.
Use the
undo ssh-server source-interface
that, the source address in the packets sent to the SSH2 client is determined by the system.
ssh server rekey-interval
Use the
ssh server rekey-interval
ssh-server source-ip
Use the
ssh-server source-ip
ssh server timeout
Use the
ssh server timeout
ssh user assign rsa-key
Use the
ssh user assign rsa-key
ssh user authentication-type
Use the
ssh user authentication-type
for an SSH user.
ssh user service-type
Use the
ssh user service-type
command to add a new community name or, if you use the V3 parameter,
command to configure the public SNMP host for members inside a cluster on the
command to filter the source (and group) address of multicast data packets.
command to configure the transmission rate on the AUX (Console) port.
command to configure the port speed.
command, you can configure the route calculation interval of OSPF.
spf-schedule-interval
command to specify on the client the public key for the server to be
command to define update interval of server key pair.
ip-addr command to specify source IP address for the SSH server.
command to set authentication timeout time for SSH connections.
command to allocate public keys to SSH users.
command to specify service type for a user.
command to configure the client to run the initial authentication.
command to set authentication retry number for SSH
command to specify source interface for the SSH server. If you
command to clear the source interface configuration. After
command to define on the server the available authentication type
3Com Switch 5500 Family
Quick Reference Guide
System view
Cluster view
PIM view
User Interface view
Ethernet Port view
OSPF view
System view
System view
System view
System view
System view
System view
System view
System view
System view
System view