Software Installation - Mac Os - FELIXrobotics FELIX 3.0 User Manual

Press the upload button, and wait till the upload is complete. This normally takes between 1 to 2 minutes.
6.
The new firmware is now on your printer.
4.2 Software Installation – Mac OS
1. Plug in the power supply cable.
NOTE: The electronics board is NOT USB powered, so without the power cable the
electronics won't work. It needs the voltage of the purple wire to drive the logic of the board.
The power to the rest of the board is controlled by the CPU when needed.
2. Plug in the USB cable into the computer
3. Download Mac-drivers from: http://www.ftdichip.com/Drivers/VCP.htm.
4. Download repetier software (.dmg file) from:
http://shop.felixprinters.com/downloads/index.php?path=software/
5. Open .dmg file and copy Repetier-Host.app to your Application folder
6. Download latest printer profiles from
http://shop.felixprinters.com/downloads/index.php?path=software%2Fsfact+slicing+profiles/
support@FELIXprinters.com
www.FELIXprinters.com
User manual FELIX 3.0 3d printer
http://www.repetier.com/download/ or from