FELIXrobotics FELIX 3.0 User Manual page 55

The following checks are endurance tests which are done before assembled printers are released to our
customers. For assembled printers the printed parts generated are supplied with the printer.
No Printing checks
20. All I/O working properly
21. 00_test_thinwall_v3_export.gcode,
22. 02b_print_assy_display_unit_F3_0.gcode,
23. 03_print_assy_felix_single_extruder_V3.gcode,
extruder 1
24. NOTE: Only print for single extruder printer.
05_Extruder_cover_single_extruder_V2.gcode,
25. 00_test_thinwall_v3_export.gcode ,
26. 06_cover_dual_extruder_V7.gcode,
27. NOTE: Before printing this, make sure extruder cover is already mounted.
01_calibration_dual_extruder.gcode,
28. 04_print_assy_felix_accessoires_dual_extruder.gcode,
The following checks are required for CE safety.
No CE safety checks
29. Heat shield mounted onto extruder.
30. Heat warning signs placed according to manual
31. Usage of gloves warning signs placed according to manual
32. Pinching danger warning signs placed according to manual
33. Handle is mounted properly
34. Check if damping feet are placed underneath printer
35. All four bolts tight on electronics enclosure?
36. CE label is mounted according to instructions?
37. Serial number sticker is mounted onto CE sticker?
38. Checklist signed by authorized person.
support@FELIXprinters.com
www.FELIXprinters.com
print small test with extruder 1
print display unit case with extruder 1
NOTE: Following prints are only needed for Dual extruder printer
print small test with extruder 1
with extruder 2
calibrate distance between nozzles
User manual FELIX 3.0 3d printer
print accessory set part 1, with
with extruder 1
print accessory set part 2
Check
Check