FELIXrobotics FELIX 3.0 User Manual page 17

-
Make sure the bed is at least 5 cm from the hot-end, to give you enough reaction time to respond if
something goes wrong.
-
Press Home X, then move the x axis back and forth.
-
Press Home Y, move the y axis back and forth.
-
Press Home Z
-
The distance between the table and hot-end is probably too large.
1. Rough adjustment
-
Turn the screw in such a way that the flexible vane mechanism goes downwards. Do this approx. till ¾
of the possible stroke. Move the complete part a little bit up and press Home Z again.
-
Repeat this process until the table is approx. 3 mm from the nozzle. Now fix the bracket to the frame
and start homing again. Repeat this procedure to get the nozzle closer and closer by turning the little
screw as shown in the picture above.
-
Do this a couple of times until the distance is less than the thickness of a piece of normal paper.
Example:
Too far: Big gap
In the manual control tab
-
Check if the switchable fan mounted to the airduct is working.
Move the slider to 100% and press the fan button
support@FELIXprinters.com
www.FELIXprinters.com
2. Fine adjustment
Too close: Nozzle hits table
User manual FELIX 3.0 3d printer
 No airgap
 No contact between nozzle
and table