Make A Dual Extrusion Print; Support Material With Second Extruder - FELIXrobotics FELIX 3.0 User Manual

If satisfied, press save:
Load the just saved .gcode file in repetier-host to print it on your FELIXprinter.

7.2.2 Make a dual extrusion print

These steps will demonstrate how to make a dual extrusion print with Kisslicer. Two examples will be
shown.
-
How to use the second extruder to print support material
-
How to use the second extruder to print a selected object.
-
7.2.2.1

Support material with second extruder

Load a STL file which requires support material to print properly.
Choose a quality, it is recommended to start with normal quality.
Support type: Normal – Dual extrusion
Printer: FELIX 3.0 – Dual Extruder
Inside the printer tab goto extruder material and choose the materials currently loaded in the extruders.
Also note the default extruder mapping area. Here you can also select which structure types each
extruder should print. In this example just go with the default settings.
support@FELIXprinters.com
www.FELIXprinters.com
User manual FELIX 3.0 3d printer