Safety - FELIXrobotics FELIX 3.0 User Manual

14 Safety

To safely operate the FELIXprinter, we advise that you keep the following safety recommendations in mind:
1. Keep children under the age of 14 out of reach of the FELIXprinter
2. Caution with any moving parts that move in the X, Y and Z direction. At the end of each moving part
there is a pinching hazard.
3. Watch out for any other non-protected sharp edges of the printer.
4. Don't lay objects on the heated bed that are not being printed, not even when the printer is turned
off.
5. Only use the materials polyactide (PLA), Acrylonitrile butadiene styrene (ABS) or Arnitel as printing
material. Consult FELIXprinters if you want to use a different material.
6. FELIXprinters are only suitable for professional use.
7. When removing or feeding material to the hot end, wearing heat-resistant gloves is recommended.
8. Only operate the FELIXprinter in a sufficiently ventilated environment (fumes from ABS and PLA
aren't toxic, but can cause respiratory irritation).
9. Don't lean on the FELIXprinter when it is operating.
10. Make sure all moving parts can move without any obstructions.
11. Don't remove any objects from the hot plate while the printer is still printing objects.
12. Don't transport the FELIXprinter when it is in operation.
13. Do not use a different power supply than the provided power supply, it can be dangerous and cause
electronical malfunctions.
14. Use the FELIXprinter in a dry environment.
15. Use the FELIXprinter on a stable and leveled surface.
16. When moving the FELIXprinter only use the handle on top.
17. Turn off the FELIXprinter when errors occur.
18. When operating the FELIXprinter, be carefull with long hair and loose clothes.
19. When unattended, turn off the FELIXprinter.
20. Place the FELIXprinter on a table/Desk or something with a similar height. This will keep it safe from
small children.
support@FELIXprinters.com
www.FELIXprinters.com
User manual FELIX 3.0 3d printer