Step 2 - FELIXrobotics FELIX 3.0 User Manual

3.1.2 Step 2: X-direction
Calibration in x-direction
4. Make sure there is at least 1mm separation between table hot-end.
5. Move the table to the middle of its movement range slowly.
Adjustment nut
6. Move the X-axis carriage over its movement range slowly. While moving check the distance between the hot-end and
bed. If the distance is not even, adjust it with the nut which supports the middle of the table.
7. Move the table a little closer to the hot-end and repeat the previous step to more precisely determine the distance
between the hot-end and the table over the whole length.
You have successfully calibrated the table.
support@FELIXprinters.com
www.FELIXprinters.com
User manual FELIX 3.0 3d printer