Slic3R - FELIXrobotics FELIX 3.0 User Manual

7.1.1.2

SLIC3R

Slic3r is an alternative slicer to the recommended CuraEngine.
Print and printer settings:
With these settings you can print in two modes.
1. Single head printing
2. Dual head printing.
1. Single head printing:
To enable this, configure it like this:
Print settings: choose one of the qualities with where the second number is a 1.
So for instance 1_1_Normal Quality (200 micron). This enables single head mode.
Printer settings: Choose FELIX 3.0 Single
2. Dual head printing:
Print settings: choose one of the qualities with where the second number in the print settings is a 2.
So for instance 1_2_Normal Quality (200 micron) enables dual head mode.
Printer settings: Choose FELIX 3.0 Duo.
This will print support material with the second extruder.
Filament Settings:
Extruder 1: choose your filament type
Extruder 2: choose your filament type, this one will be ignored if you have the print and printer settings
configured for single head mode.
support@FELIXprinters.com
www.FELIXprinters.com
User manual FELIX 3.0 3d printer