Firmware Installation - Arduino - FELIXrobotics FELIX 3.0 User Manual

4.1.3 Firmware installation – Arduino
NOTE: Only continue with this subchapter if:
1. You have just assembled your DIY kit DUAL extruder 3d printer or
2. You want to update the firmware of your printer because there is new firmware
available.
This chapter explains how to update the firmware on the electronics board of your printer.
This step requires the following software:
-
Arduino, http://arduino.cc/en/Main/Software
-
FELIXprinter firmware (check the revision of the printer). Contains printer settings for correct
operation of your FELIXprinter.
Steps to upload new firmware to the control board:
Download the latest firmware here:
1.
http://www.felixprinters.com/downloads/index.php?path=firmware/
Be sure to download the printer firmware that matches your printer version.
Extract the firmware .zip file.
Install the Arduino software, and run it.
2.
Open the firmware file from the extracted firmware folder.
3.
In this case it is Repetier.ino, it could also be Marlin.ino.
Select the correct platform:
4.
Select the correct Serial (COM) Port, which you noted earlier.
5.
support@FELIXprinters.com
www.FELIXprinters.com
User manual FELIX 3.0 3d printer
platform to upload firmware to the printer.