Britax Roundabout User Manual page 6

5. Carefully kneel on your
6. Your Roundabout should
Roundabout to push it into the
now be secure - see "Buckle
seat and pull the lap belt tight.
Position" on page 22. To
remove your Roundabout,
simply unfasten the belt and
reverse the above.
18
Lap and Shoulder Belt Installation
5. Pull the shoulder section
6. Pull the shoulder section,
here while ushing down on
close the clamping arm,
~~;f~;un
cr about
to ensure a
move the tab over until the
arm is locked closed. Your
Roundabout should now be
secure.
Note: Use the lock-off on the side closest to you. One lock-off
is adequate.
If the vehicle seat belt buckle interferes with the lock-off, use
the other side.
Note that the lock-off appearance may vary from above illustration.
If you have problems stabilizing your Roundabout, use a rolled
towel to level the Roundabout's base in your vehicle seat. The
bottom surface of the Roundabout's base should be horizontal.
Caution: Do not raise the base beyond horizontal; this could reduce
the protection to your child.
Securing the Roundabout using the Versa-TetherTM will also help
stabilize the child seat. The rearward facing installation is always
im roved by the use of the Versa-TetherTM. (see pages 25 and
26 P
20
Lap Belt Only Installation
2. Pass the seat belt through
both rearward-facing slots.
seat and pull the harness snug. Make sure lock-off closest to
you is open.
3. Fasten the seat belt.
CAUTION:
Never bend the plastic lock-off
belts are passed behind the
arm up or down... tt WIII break
buckle strap.
Off!
2. Pass the lap belt through
seat and pull the harness snug.
both rearward-facing slots.
Make sure lock-off closest to
3. Fasten the lap belt.
CAUTION:
you is open.
Never bend the plastic lock-
off arm up or down...it will
DUCKI?
strap.
break off!
19
21
Brltax Roundabout Convertible Chi l d Restramt page 5 of 9