Britax Roundabout User Manual page 14

This is a lap belt. Most vehicles 1. Check the angle of the base.
This is a lap and shoulder belt.
1. Place your child seat forward-
have a lap belt in the center of For recline fold the base under
facing on the vehicle seat. Then
the chdl
loosen the harness by oushinq
the rear seat.
_ - _ _.
the release button in as you pull
the shoulder straps out.
I
the seat surface. fvlake sure the
I
top end rests on the front seat
2. Let the foot end of the Elite
rest about 12" (30cml above
back.
13
.
.
the belt slot, over the shell,
3. Run the seat belts under the
far side of the Elite, up throuqh
down through the other slot,
and buckle.
4. Tiqhten the wcbbinq by 5. If hard to trghten, thread the
pushing the Elite down into the
seat belt over the side, down,
vehrcle seat, and pullrng the seat
across the underside of the shell.
belt
up through the other slot, and
down to the buckle.
6. Trghten the webbrng by
pushrng the Elate down Into the
vchrcle scat and pullrng the seat
belt.
7. Move the front seats
rearward to squeeze the Elite In
place between the front and
back seats. The front seats do
not need to be symmetrical.
Recheck tensron on seat belt
!. Pull the seat belt out and hold
the lap and shoulder sections
together. Keep them together
as you pass the seat belt through
the first seat belt routing slot,
indicated in red on your Elite.
15
through'the second seat belt
routing slot to the front of your
child seat.
4. Pull all the slack from the seat
5a. Carefully kneel on your Elite
belt to the front of your child
to push it into the vehicle seat.
seat and then fasten the seat
Pull the seat belt here to tighten
belt.
the lap section...
5b. . ..and then oull the shoulder
6. Your Elate should now be
section of the'seat belt tight
secure To remove your Elrtc
here.
srmply unfasten the scat belt
and unthread It.
14
Britax Elate Convertrble Child Restraint page 4 of 7
16