Britax Roundabout User Manual page 13

I\- u
/I I
I
5. Slide the chest clip up to the
middle of the chest.
6. To open the chest clip,
squeeze the middle tabs.
(Some chest clips have only
one tab.) The correct height
for the cli is the middle of the
chest, at t R e level of the armpit.
Always make sure that the
harness is snug at each use or
after any adjustments.
9
First note that some vehicles have no seating positions which are
compatible with the Elite (or any child seat). Read this section
carefully. If in doubt, return to your vehicle or Britax dealer for
help.
There are several types of vehicle belts that will not work with
Elite:
l
Front seat belts with anchorages (top or bottom) in the door.
l
Motor driven automatic belts of any kind.
l
Non-locking (ELR) two-point seat-belts.
l
Seat belts specified by your vehicle manufacturer as
incompatible with child seats.
The handbook for your vehicle will have information on the types
of seat belts in your vehicle. If you have belts of the above-listed
types, select another seating position. Elite will work with rear
seat three-point seat-belts with a sliding latch plate, and with rear
seat three-point seat-belts that are specifically marked as appropriate
for child seats. The middle rear seat of most vehicles has a lap belt
which most often will work with the Elite.
Your Elite can be securely fitted in many vehicles using their existing
seat-belts. However, some types of vehicle desrgn prevent you
from making a good installation due to the positron of the seat-
belt lower anchorage points (an anchorage point is the point
where your seat belt and buckle are attached to the vehicle).
Use your Elite rearward-facin
i
from the time your baby grows
out of the infant carrier
until t e baby is at least one year of age.
As long as the child and you are happy with rearward-facing,
use the seat that wav. It can be used rearward-facing until the
hid reaches 32 Ibs.*
This is a lao and shoulder belt.
&Lap Belt 1
.._ ._ - ._r -
Most vehrcles have them in the
outboard rear seat.
1. Adjust the angle of the Elite 1. Adjust the angle of the Elite
with the swinging base. For with the swinging base. For
infant recline in most vehicles. infant recline in most vehicles.
flip the base beneath the shell. flip the base beneath the shell.
I
I I
2. Let the foot end of the Elite
"3. Run the seat belts over the
rest about 12" (30cm) above
far side of the Elite, down
the seat surface. Make sure the
through the belt slot, under the
top end rests on the front seat
shell, up through the outer slot,
back.
and buckle.
11
I I\\
I
4. Put your knee into the Elite.
5. Move the front seat back so
Pull the shoulder strap (the that the Elite is squeezed
uppermost webbing) until the
between the front and back
lap section is tight. Then tighten
seats. Recheck the seat belt and
the shoulder strap.
re-tension if necessary. An
optional tether strap, "Versa-
TetherTM ", may be obtained
from your Britax dealer.
10
12
Britax Elite Convertible Child Restraint page 3 of 7