Britax Roundabout User Manual page 25

To protect your child in a crash. you must use the Cruiser together wth seat belts
that are compatible. Different vehicles have ddferent types of seat belts. The Cruiser
must be uxd only with a lap 6 shoulder seat belt. Under no circumstances should
you ilse the Crwser wth two pomt seat belts (lap belt only or shoulder belt onl )
your child wall be seriously injured
in the event of a crash1 There are lap & shoul d er
seat belts that will not work with the Cruiser. If your car has seat belts which are
attached to the door at the top or at the
bottom,
such belts will not work with !he
Cruiser. Cruiser is onl
cl
intended for UK in vehicle seats that are forward facing. This
restraint is not inten
ed for use in seats that are rearward facing or side facing. Do
not use it in such seats.
This restraint is not certified for aircraft use. Aircraft seats have only lap belts.
If
K,
ou have any questions about what kind of belts you have, please refer to you
ve ~cle's lnstructlon book or return to the store where ou purchased
the Cruiser.
The store will be happy to help you determine if the be tr are compatible wth the
Y
use of the Cruiser.
This is a lap & shoulder seat belt.
A. Shoulder iedion.
B. lap section.
1, Place the Cruiser in our car, making
sure It is pushed firm y back into the r
passenger seat. Sit your child on the
truiser.-
I
2. Move the head support up or down
so that the slot m the seat belt guide is
3. Fasten the lap L shoulder belt across
level with your child's shoulder.
the Cruiser. The lap section of the belt
should sit as far forward as possible over
the hips. Make sure the belt is not twisted.
6
4 Thread the shoulder secbon of the belt
through the belt guide as shown.
5. Pull the shoulder belt here to tighten
the
l a p Sect,o".
NOTE Children will
rometlmes try to put the shoulder belt
under thetr arm. Correct thus immediately
an mcorrectly worn belt V/III cause
I
6. With
6
our other hand pull the shoulder 7. Your child and Cruiser should now be
belt tlg t through the seat-belt guide
secure
Again, make sure the seat-belt is not
twlrted
Releasing Your Child
To release your child from the Cru~scr
rlmolv unbuckle the belt
Do not leave your Crwrer loose Always fasten the belt across the Cru~rer when tt 15
not being used by your child
REMEMBER - NO CHILD SEAT IS ESCAPE PROOF!
In the event of an emergent
for quick release Children
I K
rest b~ltr are dwgned to meet the rxojin,red standard
ould be educated to not play with the seat belt buckle
After an accldelt, the Cxlie: and seat belts should be replaced Although they may
look undamaged. there can be hldden damage or weakness
WARNING!
Use the Cruiser i n vehicle seats
which are forward facing only!
Do not use on rearward-facing
or side facing vehicle seats.
You must use forward-facing
vehicle seats with this restraint.
Side-facing or rear-facing
vehicle seats i n vans, station
wagons or trucks CANNOT be
used with this restraint.
8
The cover of the Cruiser IS held in place by a apper on the back side and a
panel with velcro behind the child. Open the ripper and the panel and
carefully remove the cover.
CLEANING THE COVER
Read the label on the cover for washing instructions. The cover is machme
washable.
DO NOT machine dry the cover - drip dry only
CLEANING THE HARNESS AND SEAT
only use hand soap and warm water.
DO NOT take the head support apart when removmg the covet or cleanmg
the Cwser It IS unnecessary and WIII damage the Cruiser
DO NOT use solvents. detergents or cleaning fluad as these may weaken the
belts or seat structure.
I
I I I
I
Taking Off The Cover - Step 1
Lay the Cruiser on a clean, flat sur-
Taking Off The Cover - Step 2
Unhook the elastic loops from the
face and undo the hook and eye
seat belt guides and gently pull off
found underneath the head support
the head support cover
LOVCl
Britax Cruiser Booster Seat for Lap/Shoulder Belts page 2 of 4