Finishing Transport Fault Codes; Third-Party Dfa Fault Codes - Xerox D95 User Manual

Standard Finisher Plus

Finishing Transport fault codes

If an error code appears that is not listed in the table below, or if an error persists after
following the listed solution, then contact your Xerox Customer Support Center.
Fault code
051 900, 051 100, 051 101,
051 102, 051 103, 051 104,
051 105, 051 106, 051 107,
051 108, 051 109, 051 110,
051 111
051 300
051 210
051 211
051 310

Third-party DFA fault codes

The following table provides a list of fault codes that indicate that a jam or fault has
occurred in the attached third-party, Document Finishing Architecture (DFA) device.
If an error code appears that is not listed in the table below, or if an error persists after
following the listed solution, then contact your Xerox Customer Support Center.
Fault code
051 910, 051 911
23-40
Possible cause
Paper jam
Finishing Transport front
door is open.
Registration clutch
solenoid fault
Diverter solenoid fault
Finishing Transport
firmware fault upgrade
Possible cause
Either the DFA device is
not ready or other fault
has occurred with it.
Recommended solution
• Check for any obstructions or
paper jams in the Finishing
Module and Finishing Transport
paper paths and clear them.
• If necessary, power Off/On the
machine, and if necessary,
resend/restart your print job.
• If the fault persists, contact the
Customer Support Center.
Close the front door of the Finishing
Transport.
• If necessary, power Off/On the
machine, and if necessary,
resend/restart your print job.
• If the fault persists, contact the
Customer Support Center.
Recommended solution
• Refer to any user documentation
that came with your DFA device
and follow the instructions to
bring the device back online.
• If necessary, power Off/On the
machine, and if necessary,
resend/restart your print job.
• If the fault persists, contact the
Customer Support Center.
®
Xerox D95/D110/D125 Copier/Printer
User Guide