Figure 32. Output Settings - Vision VA61 User's Reference Manual

VA6x User's Reference
5. Click on "Setting" beside "Output Settings" in the I/O Controls" panel (Figure 30), to open
the Output Settings window (Figure 32).
The VA61 uses only Output 2. The DCI-100 supports both Output 1 and Output 2. If the strobe
signal goes through the VA61 connectors,
6. Configure the "Event Mode" and the Strobe Out delay and duration.
7. Click on "Output 2" at the top of this window.
8. Configure the "Event Mode" and the Strobe Out delay and duration.
NOTE
If the Event Mode for either Output1 or Output2 is set to "Close" or "Open"
these outputs will appear in Sherlock's "digital outputs" and change the stan-
dard output channel number assignments. If Output1 and Output2 are set to
Strobe or Pulse functions, they will not appear in Sherlock's digital outputs.
52

Figure 32. Output Settings

405-00022-00
Rev 06; 7 April 2011