Sapera Camexpert; Saperalt Runtime; Genie Framework - Vision VA61 User's Reference Manual

Gige camera vision appliance

Table of Contents

405-00022-00

• DCI-100 I/O drivers. Configures the programmable logic thresholds on the DCI-100 Module,

through the VA61 or PC serial port. The DCI-100 provides a way to connect camera power and

I/O, separate from the VA61 camera power and I/O connectors.

• Acquisition driver for the iNspect/iLabel application. Cameras are ordered by IP Address.

• Acquire and display images. The default camera settings of this program are temporarily writ-

ten to the camera , to allow display in this utility. The camera settings in this program are not

used by the other application programs. Note: Changing the Camera Name in this program

may make the camera unaccessible to the Sherlock and SaperaLT software.

Sapera CamExpert

• Change camera configuration settings, such as exposure time, white balance, gain, color out-

put format. Gain and exposure time can also be changed from Sherlock and iNspect/iLabel.

• Save camera settings to the camera memory or a configuration file. You can configure the cam-

era to load either your saved settings, or the factory settings, at power up. The preferred method

is to save your settings to the camera and load them at power up. If multiple configurations are

needed, you can save them to camera configuration files. Several example configuration files

are included on the VA61.

• Acquire and display images. Changes to the camera settings are temporary, unless saved to the

camera memory or to a configuration file.

• Acquisition utility for the Sherlock software. Sapera LT is used with the drivers in the Genie

Framework.

• Acquisition drivers for the SaperaLT and Sherlock software. Firmware update utility. A Sys-

tem tray icon provides status on the Genie camera connections. (available, unavailable, dis-

connected).

• Sapera Network Configuration Tool. Note: Changing the Camera Name in this program may

make the camera unaccessible to the Sherlock and SaperaLT software. Advanced–Recover

Camera can be used to reset the camera IP Address to DHCP/LLA, following the display steps.

Rev 06; 7 April 2011

VA6x User's Reference

Table of Contents