Camera Control & Power Cable; Cable Pin-Out; Figure 3. Control And Power Cable - Vision VA61 User's Reference Manual

405-00022-00
Camera Control & Power Cable
The VA61 provides two standard DB15 or 15-pin D-Sub connectors for Camera I/O signals to
control trigger and receive strobe. 12 Volt power is also available on this connector.
• The camera can be triggered through the VA61 I/O. The external trigger(s) would be input at
the 25-pin Industrial I/O connector, and output to the cameras through the DB15 connectors, as
Camera IN2 (each camera), illustrated in Figure 1 on page 15.
• The camera may have a Strobe output, that can be connected to the VA61 through the DB15
connectors, as Camera OUT2, and output to external lighting control equipment through the
25-pin Industrial I/O connector.
NOTE iNspect, iLabel, and Sherlock assume IN2 is the camera trigger input, and
OUT2 is the camera strobe output. If you use CamExpert to create a camera con-
figuration file, make sure you use In2 for trigger, and Out2 for strobe.
Camera 12-Pin Hirose Description
1
2
3
4
5
6
7
8
9, 10
11
12
12 pins
Rev 06; 7 April 2011

Cable Pin-Out

Direction
Power Ground
+12 Volt Power
OUT 1 –
OUT 1 + Camera Output
IN 1 –
IN 1 + Camera Input
Out 2+ / Strobe Camera Output
Out 2 –
No Connection
IN 2 + / Trigger Camera Input
IN 2 –
see below

Figure 3. Control and Power Cable

Part Number
A-CAB-GTP-00
A-CAB-GTP-01
A-CAB-GTP-02
VA61 15-Pin DB15
10
15
7 (no connection on VA61)
13 (no connection on VA61)
8 (no connection on VA61)
14 (no connection on VA61)
12
6
1,2,3,5,11
9
4
Cable Length
3 meters
5 meters
10 meters
VA6x User's Reference
15 pins
19