Table of Contents
Advertisement
VA6x User's Reference
Camera Data Connectors
The GigE camera data ports are standard Ethernet RJ-45 8-pin male connectors, located directly
below the camera power and control connectors. Camera Port One is assigned a Static IP Address
10.1.64.5 and Camera Port Two is assigned a Static IP Address 10.1.128.7. The VA-Genie Cam-
era Setup program configures the two cameras for compatible Static addresses. The Ethernet
ports are also configured (starting March 2008) for Jumbo Frames and maximum Receive Des-
criptors (see pages 25 and 26 in the Genie Camera Manual).
CamPort1 is defined in Windows as PCI Bus 1 Device 1. CamPort2 is defined in Windows as PCI
Bus 1 Device 14. This information may be needed if you must install a custom hardware driver.
Pin
Name
1
TD+
2
TD–
3
RD+
4,5,7,8 NC
6
RD–
Power Connector
The VA61 is powered from an external supply (option A-PWR-NSII) that connects to the 3-pin
male D-Sub connector on the back panel. The power requirements are:
+24 V +/–10% @ 2.5 A maximum.
Pin
Name
1
GND
2
+24V
3
NC
A power cable (A-CAB-NSII-PWR), with open leads on one end and a mating connector plug on
the other, is shipped standard with the product.
36
Ethernet Pinout
Direction
Description
Out
Transmit Data+
Out
Transmit Data–
In
Receive Data+
–
not connected
In
Receive Data–
Pin 1
Figure 15. Power Connector
Power Connector Pinout
Direction
Description
–
Ground
Input
DC Power
–
not connected
405-00022-00
Rev 06; 7 April 2011
Advertisement
Table of Contents
