System Accessories Overview; 323003-Riser Shunt; Dip Switch Setting Instruction; System Configuration Instructions - Bticino D45 Technical Manual

System accessories overview

323003 - riser shunt
The riser shunt is used to connect the riser BUS and system
BUS in order to separate BUS, transfer signal and switch
between video and audio channels . The device has five Rj45
connectors, which are for riser BUS input/ output, system
BUS input/ output . The last Rj45 and two other connectors
are designed to connect the riser system to the main power
supply . The device also has 2 4-gear video gain DIP switches
for video channel from the EP to the system BUS, and video
channel from the system BUS to the HANDSET . The video
transfer distance can be increased by adjusting the gain . By
installing several items 323003 in cascade, the riser systems
can be connected as a network and managed as districts .
7 8
1 2 3
legenD
1 . Riser system power supply input connector
2 . Riser system power supply input connector
3 . Input connector for riser system: SUB SYSTEM IN
interface for 323002
4 . Entrance panel: riser entrance panel output connector
5 . Output connector for SYSTEM OUT BUS: connect the
SYSTEM IN interface of next 323003 or 323001 related
interface
6 . System BUS connector for SYSTEM IN: connect last
323003 SYSTEM OUT interface or leave empty
7 . System configurator connector: insert resistor
8 . Configuration connector for updating the software and
connect the PC in series
9 . Adjust switch of video channel gain from the system BUS
to the riser handset
10 . Adjust switch of video channel gain from the riser
entrance panel to the system BUS
9 10
4 4
3 3
2 2
1 1
4 5 6
Riser shunt
Note: (2 – 6) these five terminals are Rj45 connectors, use a cAT5 cable.
Indication lights
- cFG: configuration guide
- PoWER: Power supply
- L1 L2: Intercom status
- S1: confirmation
- S2: Input
on
oFF
The following table indicates the video amplifying gains .
During the installation, the parameters need to be adjusted
according to image requirements .

DIP switch setting instruction

Distance
0 – 300 m
colour video
300 – 700 m
signal
700 – 1000 m
1000 –1500 m
b/w video signal
1500 – 2000 m

system conFiguration instructions

The system configuration for the Riser Shunt consists in
assigning a number to item 323003, setting the address
range managed by item 323003, and selecting the system
configuration mode . Only if the configuration is correct can
the system work correctly . There are 3 configuration methods .
The configurator alternative enjoys the highest priority . If the
physical configurator is used on the Riser shunt, then the
other configuration methods will be ineffective .
Note: if use physical configurator method is used, the power of item 323003 should
disconnected after the configurator has been installed, and then reconnected to
activate the configuration.
4
3
2
1
1 2 3 4
OFF OFF OFF OFF
ON OFF OFF OFF
ON ON OFF OFF
ON ON ON OFF
ON ON ON ON
35