Recovering All The Default Parameters; Exit Installation Setting - Bticino D45 Technical Manual

Recovering all the default parameters

FuncTions operaTion
Select setup submenu of "recover all the While in the initial installation setup status, press and hold the MC pushbutton nine times to enter the setup submenu
default parameters" "recover all the default parameters".
Set the parameter Press MC pushbutton to recover all the installation setup parameters. The message light will be on.
Exit
1) Press the door lock release pushbutton to exit the current submenu and return to the initial installation setup status.
2) If the operation is performed wrongly, 3 short beeps will be heard the unit will automatically return to the initial
installation setup status.

Exit installation setting

Press and hold the door lock release pushbutton until 1 long
beep is heard . Release to exit setup status . If while in setup
status no operation is performed for 10 s, the handset will
automatically return to standby .
instructions:
1 . For all pushbuttons, the operation is only performed
after the pushbutton is released . If necessary to hold
the pushbutton, this should only be released after one
extended beep is heard .
2 . Operation indication: a short beep indicates that the
operation has been successful; 3 short beeps or busy
tone indicate unsuccessful operation, or system is busy .
3 . In power saving mode, the handset is able to receive but
not make calls .
receiving calls
Receiving calls from the EP:
When the handset rings, and the call light flashes quickly, it
means that a call is coming . The display will show the picture
recorded by EP camera; press the answer pushbutton or pick
up the handset to accept the calls . While the system is busy
with the conversation the call light will flash slowly . Press
the answer pushbutton or put down the receiver to end the
call, and the device will come back to standby status . Unless
otherwise specified, "EP" in this manual means main EP or UEP .
Note: for Handsfree handsets, both answering and terminating a call are done by
pressing the answer pushbutton; for Standard handsets, pick up the receiver to
answer the call and put down the receiver to terminate the call
Receiving calls from Small EPs:
The handset will ring . The procedures are the same as
explained in "Receiving calls from the EP" .
Receiving calls from the Switchboard:
When the handset rings, and the call light flashes quickly, it
means that a call is coming . Press the answer pushbutton
or pick up the handset to accept the calls . While the system
is busy with the conversation the call light will flash slowly .
Press the answer pushbutton or put down the receiver to end
the call, and the device will come back to standby status .
Receiving internal calls:
The handset will ring . The procedures are the same as
explained in "Receiving calls from the EP", but without video .
calling other Devices
All Switchboards
While in standby press the MC pushbutton to call
Switchboards and wait for the call to be answered . Replace
the handset to end the conversation . The device will go
back to standby .
Note: for standard handsets you must pick up the handset to start conversation.
Calling internal handsets
While in standby, press and hold the (MC) Switchboard call
pushbutton until 1 long beep is heard . After release, the call
made will be an internal call . Replace the handset to end the
conversation . The device will go back to standby .
reMarks
Default: disable. this means that the handset is
not set to connect to the apartment interface
29