Simplified Programming With Type Diagrams; System Type Programming - Bticino Terraneo Instructions For Use And Installation Instructions

5

SIMPLIFIED PROGRAMMING WITH TYPE DIAGRAMS

5.1

SYSTEM TYPE PROGRAMMING

This command is intended to simplify programming. After the installer has performed the
programming access procedure (Page 13) he can program the whole system by typing the
code "82" followed by the identification number (from 01 to 16) of the diagram chosen from
the 16 type configurations (see table).
As an example if the system is made up of: 1 dedicated OS, 1 Call from Floor distribution
block, 1 Camera (Separate, Dome, Living, Light or LightTech) and 1 Division, corresponding
to diagram 8, the procedure will be as follows:
1
8
# #
2 3 4
2 8
0
®
Lift the receiver
Type
Type the access code (e.g.
basic 1 2 3 4)
Wait for the start-dialling tone
Type the Macrocommand
#
corresponding to the diagram
required (e.g. 8)
When you
confirmation tone hang up
19
hear the