Cable Inspection And Lubrication/Adjusting The Rear Brake Light Switch (Brake Pedal) - KYMCO MXU 500 Owner's Manual

Hide thumbs Also See for MXU 500:

Table of Contents

. INSPECTION/ADJUSTMENT

7. Turn the rod clockwise or

counterclockwise to align the joint ball in

the rod with the hole on the shift arm,

then install and tighten the bolt and nut.

When align the joint ball in the rod with

the hole on the shift arm. Always keep

the joint ball original position, do not

turn the joint ball.

8. Tighten the lock nuts of the rod.

CABLE INSPECTION AND

Damaged cable sheath may cause

corrosion and interfere with the cable

movement. An unsafe condition may

result so replace such cable as soon as

Inspect the cable sheath.

Replace if damage.

Check the cable operation.

Lubricate or replace if unsmooth operation.

Hold cable end high and apply several

drops of lubricant to cable.

LEVER LUBRICATION

Lubricate the pivoting parts of each lever.

ADJUSTING THE REAR BRAKE

LIIGHT SWITCH (BRAKE

1. Loosen the lock nut.

2. Turn the adjusting nut clockwise or

counterclockwise until the rear brake

light comes on at the proper time.

3. Tighten the lock nut securely.

Chapters

Table of Contents