Cargo Lamp; Windshield Wipers And Washers; Windshield Wiper Operation; Intermittent Wiper System - Jeep WRANGLER 2017 User Manual

Cargo Lamp

The courtesy and dome lights will turn on
when the front doors are opened, by rotating
the control for the dimmer switch on the
multifunction lever fully upward, or if
equipped, when the unlock button is pushed
on the Remote Keyless Entry key fob.
The sports bar reading lights (available on
four-door models) can be turned on by push-
ing the switches, located on either side of the
lens. Push a switch a second time to turn the
light off.
The rear cargo light may be turned on by
pushing the lens. Push the lens a second
time to turn the light off.
When a door is open and the interior lights
are on, rotating the dimmer control to the
extreme bottom position will cause all the
interior lights to turn off. This is also known
as the "Party" mode because it allows the
doors to stay open for extended periods of
time without discharging the vehicle's bat-
tery.
34
WINDSHIELD WIPERS AND
WASHERS
Wiper/Washer Lever
The windshield wiper/washer control lever is
located on the right side of the steering
column. The front wipers are operated by
rotating a switch, located at the end of the
lever. For information on using the rear win-
dow wiper/washer, refer to "Rear Window
Wiper/Washer" in this section for more infor-
mation.

Windshield Wiper Operation

Rotate the end of the lever upward to the
second detent past the intermittent settings
for low-speed wiper operation. Rotate the end
of the lever upward to the third detent past
the intermittent settings for high-speed wiper
operation.
CAUTION!
In cold weather, always turn off the wiper
switch and allow the wipers to return to the
park position before turning off the en-
gine. If the wiper switch is left on and the
wipers freeze to the windshield, damage to
the wiper motor may occur when the ve-
hicle is restarted.

Intermittent Wiper System

Use the intermittent wiper when weather
conditions make a single wiping cycle, with a
variable pause between cycles, desirable. Ro-
tate the end of the lever to the first detent
position for one of five intermittent settings.
The delay cycle can be set anywhere between
1 to 18 seconds.