To Unlock The Doors And Swing Gate; To Lock The Doors And Swing Gate - Jeep 2007 wrangler Owner's Manual

NOTE: The line of transmission must not be blocked
with metal objects.

To Unlock the Doors and Swing Gate

Press and release the "Unlock" button on the key fob
once to unlock only the driver's door or twice to unlock
all the doors and swing gate. When the "Unlock" button
is pressed, the illuminated entry will initiate, and the
parking lights will flash on twice.
The system can be programmed to unlock all the doors
upon the first "Unlock" button press by using the follow-
ing procedure:
1. Press and hold the "Lock" button on a programmed
key fob.
2. Continue to hold the "Lock" button at least 4 seconds,
but not longer than 10 seconds, then press and hold the
"Unlock" button.
3. Release both buttons at the same time.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 21
4. Test the feature while outside of the vehicle, by
pressing the "Lock/Unlock" button on the keyfob.
NOTE: Pressing the "Lock" button on the keyfob while
you are inside the vehicle will activate the Security
Alarm. Opening a door with the Security Alarm activated
will cause the alarm to sound. Press the "Unlock" button
to deactivate the Security Alarm.
5. If the desired programming was not achieved or to
reactivate this feature, repeat the above steps.

To Lock the Doors and Swing Gate

Press and release the "Lock" button on the transmitter to
lock all doors. The turn signal lights will flash and the
horn will chirp once to acknowledge the lock signal. If
desired, the "Sound Horn On Lock" feature can be
turned on or off by performing the following steps:
1. Press the "Lock" button for 4 to 10 seconds.
I n f o r ma t i o n P r o v i d e d b y :
2