Table of Contents
Advertisement
5.2 Function relating to installing
(1) Service pin (Service switch)
The service pin is used at the installation of LONWORKS network.
Pressing the service pin sends out the service pin-message (control message including Neuron ID and
Program ID) to the network.
(2) Service LED
The service ID indicates the present state of the product.
In the case of LM ADAPTER under the shipment state (Non-configured state), the service LED is blinking.
(3) WINK
Upon receipt of the WINK message from the LONWORKS network, LM ADAPTER blinks the maintenance
LED 001 for about 10 seconds.
(4) Commission
After completing the binding, the set detail is reflected on the node. Doing this way allows communication
between the nodes on the LONWORKS network.
(5) XIF
To design the LONWORKS network, the configuration information of each node, interface (network
variables), etc. are required. When the product is already in your hand, such information can be obtained from
the LONWORKS network. Without the product, however, you may get it from XIF (eXternal Interface File)
locating the interface information of the product.
19
Advertisement
Table of Contents
