Power-Up Error Messages - Digital Equipment VAX 4000 108 User Information

Diagnostic Tests and Commands
•
Any parameter not entered is given a default value. Enter T 9E nn, where nn is test
number to show defaults. During power-up testing or execution of any script of tests
(A0 to BF), the values of parameters are determined by the script, not defaults.
•
You may dump the contents of a script by entering T 9E nn, where nn is a script to
dump. Scripts are always in range of A0 to BF (or 0 for the power-up script).
You must enter three zeros (0) as place holders for the three parameters that occur before
the user-specified parameter, mark_hard_SBEs. The last value (1) is a parameter. You
can then specify the mark_hard_SBEs parameter in the Memory_Init_Bitmap
test as follows:
>>> T 30 0 0 0 1
The resulting messages differ, depending on the function of the test or utility. However,
most failing tests cause the system to display error messages similar to the following:
>>> T 5F 1
? Test_Subtest_5F_18
Vec=010C Prev_Errs=0000
P5=00000000 P6=00000000
r0=00000054 r1=000082E2
r6=000082E2 r7=20008000
EPC=2005721A dser=0000 cesr=00000000 icsr=01 pcsts=F800 pcctl=FC13
cctl=00000007 bcetsts=03A0 bcedsts=0400 cefsts=00019200 nests=00
mmcdsr=00C6C600 mesr=00006000
>>>
Write down the error messages before you contact your Digital services representative.

Power-Up Error Messages

The following are examples of some error messages at power-up.
Example 1
The following is a typical example of a failed test. In this case, test E8 failed testing a
SYNC (COMM) option.
6–8 VAX 4000 Model 108 User Information
Loop_Subtest=0E Err_Type=FF
P1=00000001 P2=00000000
P7=00000000 P8=00000001
r2=00000001 r3=000082FA
r8=00008000 r9=20140758
DE_SGEC.lis
P3=827DFF03 P4=00000000
P9=00000000 P10=00000000
r4=00008230 r5=00000040
r10=13000001 r11=2014044B