Test Modes - Honeywell MS9540 Manual

H S
OST CANNER
³ 1 4 1 7
³ 1 4 1 7
³ 1 1 9 9
³ 1 1 9 9
T M
EST ODES
³ 1 1 8 0
³ 1 1 8 0
³ 1 1 8 0
³ 1 1 8 0
³ 1 1 5 5
³ 1 1 5 5
S
CANNER
C
OMMANDS
Use Protocol Prefix and Suffix for Bar Code
Transmission
1 5
* No Protocol Prefix and Suffix for Bar Code
Transmission
0 5
Enable RTS on No Read – After a NOREAD
occurs, the scanner will activate the RTS line for 20
1 7
milliseconds. The duration of the RTS activation
can be loaded in address 199 bits 6 - 0 in 10
millisecond steps.
* Disable RTS on No Read
0 7
Scanability ON - This option enters scanability test
mode. Do not enable unless instructed by a
1 7
Metrologic representative.
* Scanability OFF
0 7
Scan Count Mode ON - The scanner will enter
scan count test mode and the scanner's firmware
1 6
number will transmit to the host. Do not enable
unless instructed by a Metrologic representative.
* Scan Count Mode OFF
0 6
Power-Up with Saved Interface - Do not enable
unless instructed by a Metrologic representative.
1 2
* Power-Up with Board Interface - Do not enable
unless instructed by a Metrologic representative.
0 2
O
PERATION
35