Honeywell MS9540 Manual page 60

H H
ARDWARE ANDSHAKING
³ 1 2 4 5
³ 1 2 4 5
³ 1 2 4 5
³ 1 2 4 5
³ 1 2 4 5
³ 1 2 4 5
³ 1 2 4 5
³ 1 2 4 5
³ 1 1 5 8
³ 1 1 5 8
³ 1 1 5 9
³ 1 1 5 9
³ 1 1 5 9
³ 1 1 5 9
Invert RTS Polarity (RSV1)
-12V = Active
1 0
* Standard RTS Polarity - Use standard RTS polarity
-12V = Inactive
0 0
Invert CTS Polarity (RSV2)
-12V = Active,
1 1
* Standard CTS Polarity
-12V = Inactive,
0 1
Activate RTS, Do Not Wait for CTS (RSV3) -
Activate RTS for transmission but do not wait for
1 2
CTS to send.
* Activate RTS, Wait for CTS - Wait for CTS after
activating RTS.
0 2
Test CTS Not Present Before RTS (RSV4) - Do
not activate RTS if CTS is already present.
1 3
* Do Not Test for CTS Present Before RTS
0 3
Enable DTR Support - The scanner will stop
scanning when the Data Terminal Ready (DTR)
1 7
signal goes inactive.
* Disable DTR Support
0 7
Enable RTS Counter Toggle - The scanner will
toggle the RTS line on a good decode.
1 5
* Disable RTS Counter Toggle
0 5
Enable XON/XOFF Handshaking - The scanner
will stop transmission whenever on XOFF
1 4
(ASCII 13H) is received. Transmission will resume
after an XON (ASCII 11H) is received.
* Disable XON/XOFF Handshaking.
0 4
RS232
OK to send
Do not send
+12V = Inactive
+12V = Active
+12V = Inactive,
Do not send
+12V = Active,
OK to send
53