Please note that the MS6220 Pulsar can only be configured
using the Multi-Code Method.
To properly configure an MS9540 scanner, all programming
codes must be scanned using the CodeGate option.
Multi-Code Method
All features can be enabled or disabled using the Multi-Code Method.
A feature marked with a tilde ( ~ ) requires the Multi-Code Method.
1.
Power up the scanner.
2.
Scan the enter/exit configuration mode bar code (3 beeps).
3.
Scan the bar code for the desired feature (1 beep).
Multiple features can be enabled/disabled before
scanning the enter/exit configuration mode bar code.
4.
Scan the enter/exit configuration mode bar code (3 beeps) and
save the new configuration.
To abort a configuration change, power off the scanner before
scanning the enter/exit code.
Scan the Recall Default bar code. This will erase all previous settings and return
the scanner to its default communication protocol.
Keyboard Wedge interface scanners will load keyboard wedge defaults.
All other scanners load RS232 defaults.
Metrologic manufactures custom OEM scanners, which load the OEM's
defaults. Page 89 will explain how this affects "Metrologic Defaults."
2
B
C
C
AR
ODE
Enter/Exit Configuration Mode
³
N
EED
³
ONFIGURATION
9
9
9
9
9
T
S
O
O
TART
Recall Defaults
9
9
9
9
9
M
ETHODS
9
?
VER
8