Your new scanner has been factory configured with a set of default parameters.
Since many host systems have unique formats and protocol requirements,
Metrologic provides a wide range of configurable features that may be selected
using this bar code based configuration tool. Once the configuration is
completed, the scanner stores the settings in nonvolatile memory (NOVRAM).
NOVRAM saves the settings when the power is turned off.
Every bar code with an asterisk ( * ) is a default setting.
Bar codes with a tilde ( ~ ) require the Multi-Code configuration method.
The MetroSelect class of scanners can be bar code configured in two ways:
the Single-Code Method and the Multi-Code Method.
Please note that the MS6220 Pulsar
using the Multi-Code Method.
To properly configure an MS9540 scanner, all configuration
codes must be scanned using the CodeGate
Single-Code Method
Most features can be enabled or disabled using the Single-Code Method.
1.
Power up the scanner.
2.
Scan the bar code for the desired feature.
3.
Observe a multi-toned, "save setting" beep that indicates the configuration
has been saved to NOVRAM.
I
NTRODUCTION
B
C
C
AR
ODE
ONFIGURATION
®
can only be configured
M
ETHODS
®
option.
1