Host Scanner Commands - Honeywell MS9540 Manual

H S
OST CANNER
³ 1 1 8 0
³ 1 1 8 0
³ 1 1 8 2
³ 1 1 8 2
³ 1 1 8 0
³ 1 1 8 0
³ 1 1 8 1
³ 1 1 8 1
³ 1 1 8 1
³ 1 1 8 1
³ 1 1 5 9
³ 1 1 5 9
S
CANNER
C
OMMANDS
Enable D/E Disable Command. - The scanner will
disable scanning after it receives an ASCII "D" from
1 5
the host device. It will enable scanning when it
receives an ASCII "E".
* Disable D/E Disable.
0 5
Enable Z/R Type D/E Simulation - The scanner
will disable scanning after it receives an ASCII "Z"
1 1
from the host device. It will enable scanning when it
receives an ASCII "R".
* No Z/R Type D/E Simulation
0 1
Enable F/L Laser Command - The scanner will
turn off the laser after the scanner receives an
1 4
ASCII "F" character. The laser will turn on after it
receives an ASCII "L" character.
* Disable F/L Laser Command
0 4
Use DTR Scan Disable - The scanner will monitor
the DTR input to determine if scanning should be
1 5
allowed. A +12V "active" level enables decoding.
A -12V "inactive" level disables decoding.
* Do Not Use DTR Scan Disable - Do not monitor
the DTR input.
0 5
Activate DC2 Character - Scanning will be initiated
with the receipt of a DC2 character (^R, 124).
1 0
* Do Not Activate on DC2 Character
0 0
Transmit "METROLOGIC" with receipt of an "I"
(49H) via RS232
1 7
* Don't Transmit "METROLOGIC" with receipt of
an "I" (49H) via RS232
0 7
O
PERATION
33