Usb - Honeywell MS9540 Manual

³ 4 1 5 5
³ 9 9 9 9
♦ This feature is limited to Metrologic scanners without integrated Low Speed USB
electronics. These bar codes configure the scanner to communicate via the MX009.
³ 9 9 9 9
³ 9 9 9 9
³ 9 9 9 9
³ 3 1 6 4
³ 3 1 6 4
³ 3 1 6 4
³ 3 1 6 4
³ 3 1 6 4
If the Recall Defaults bar code is scanned while reconfiguring the scanner, the
scanner configuration will revert to the default setting, USB Keyboard Emulation
Mode. Rescan the Bi-Directional or Uni-Directional USB Serial Emulation Mode
bar code to enable the appropriate Serial Emulation Mode.
68
Enable USB Interface ♦
1 1 4
Enable Low Speed USB Defaults ♦
7 8
Load Integrated Full Speed USB Keyboard
Emulation Defaults
4 0
Load Integrated Full Speed USB IBM/OEM
Defaults
7 0
Load Integrated Low Speed USB OPOS Defaults
limited to scanners with internal Low- Speed USB
3 1
interfaces with specific software versions.
IBM OEM Scanner 4B00h Handheld – Full Speed
USB Only
3 0
IBM OEM Scanner 4A00h Flatbed – Full Speed
USB Only
0 1 0
* Enable USB Keyboard Emulation Mode
0 0
Enable Uni-Directional USB Serial Emulation Mode
Enables Uni-Directional USB Serial Emulation Mode
7 0
in Metrologic 9500/5100/4125 class products.
Enables Bi-Directional USB Serial Emulation Mode
in the Metrologic Focus/Imager class products.
Enable Bi-Directional USB Serial Emulation Mode
Enables Bi-Directional USB Serial Emulation Mode
6 0
in Metrologic 9500, 5100, and 4125 class products.
Not supported for Focus/Imager class products.

USB

–