Test Modes - Honeywell ms 7820 Solaris User Manual

S D
ECTION
Scanability ON
³ 1 1 8 0 1
The scanner will enter
scanability test mode.
Do not enable
unless instructed to
by a Metrologic
representative.
Scan Count Mode ON
³ 1 1 8 0 1
The scanner will enter scan
count test mode and the
scanner's firmware number
will transmit to the host.
Do not enable
unless instructed to
by a Metrologic
representative.
7
6
The Temporary Symbologies test
code enables all major types of bar
code symbologies, reduces the
minimum number of characters
required to 1, sets the minimum ITF
characters required to 2, and adds
the symbology name as a prefix to
the transmission. This feature is
disabled when power to the
scanner is cycled
Scanner Operation
* Scanability OFF
* Scan Count Mode OFF
Temporary Symbologies
and .
OFF ON
D
T M
EST ODES
³ 1 1 8 0 0
³ 1 1 8 0 0
³ 9 9 8 0 4
Do not enable
unless instructed to
by a Metrologic
representative
35
7
6
1