Table of Contents
Advertisement
Reset and Reload Procedures
Initializing the IP Address using normal CLI
After installing the serial port cable, you may use the CLI to communicate
with the AP-2000. You may use most generic terminal programs, such as
HyperTerminal. Once the IP Address has been assigned, use the HTTP
Interface or the CLI to complete configuration. Many web sites offer
shareware or commercial terminal programs you can download.
Use the following procedure to initialize the AP-2000 IP Address.
1. Open your terminal emulator, and then set the following connection
properties:
Com Port: <COM1, COM2, etc., depending on your computer>
Baud rate: 9600
Data Bits: 8
Stop bits: 1
Flow Control: None
Parity: None
2. Enable the "ASCII Setup" settings by selecting "Send line ends with line
feeds". Result: HyperTerminal sends a line return at the end of each line
of code.
3. Press the RESET button on the AP-2000 (located on the LED Indicator
side of the unit). Result: The terminal display shows Power On Self Tests
(POST) activity, and then displays a CLI prompt, similar to the example
below. This process may take up to 90 seconds.
[Device name]> Please enter password:
24
Advertisement
Table of Contents
