Telnet Cli Does Not Work; Tftp Server Does Not Work - ORiNOCO AP-2000 Troubleshooting Manual

Telnet CLI does not work

1. Make sure you have the proper IP Address. In the Telnet connection
dialog, enter the IP Address of the Access Point you want to connect to.
From a DOS prompt, type:
C:\> telnet <IP Address>
2. Use the CLI over the serial port to check the SNMP Table, which can be
restricting access to Telnet and HTTP. For more information refer to the
AP-2000 CLI Reference Manual.
3. Make sure you have not exceeded the maximum number of web, Telnet/
CLI, or serial CLI sessions allowed.

TFTP Server does not work

1. Make sure the TFTP Server has been started.
2. Verify the IP Address of the TFTP Server. The server may be local or
remote, so long as it has a valid IP Address.
3. Configure the TFTP Server to "point" to the folder containing the file to be
downloaded (or to the folder in which the file is to be uploaded).
4. Verify that you have the proper AP-2000 Image file name and directory
path.
Basic Setup and Configuration Problems
13