Reset And Reload Procedures; Reset To Factory Default Procedure - ORiNOCO AP-2000 Troubleshooting Manual

Reset and Reload Procedures

Reset and Reload Procedures
IP Address management is fundamental. We suggest you create a chart to
document and validate the IP addresses for your system.
If the password is lost or forgotten, you will need to reset the AP-2000 to
default values. The Reset to Factory Default procedure resets
configuration settings, but does not change the current AP Image. The
Forced Reload procedure erases the current AP Image if you need to
download a new image.
It is useful to set up the serial port and use your terminal emulator to monitor
AP-2000 activity. Serial port setup is described in "Troubleshooting".

Reset to Factory Default procedure

Use this procedure to reset the network configuration values, including the
AP-2000 IP Address, Subnet Mask, and so on. The current AP Image is not
deleted. This procedure may required if the AP-2000 password is forgotten.
1. Press and hold the RELOAD button for about 10 seconds. Result: The
AP-2000 reboots, and the factory default network values are restored.
2. If not using DHCP, use the ScanTool or normal CLI to set the AP-2000 IP
Address, Subnet Mask, and so on. Please refer to the "Command Line
Interface Reference Manual" for CLI information.
18