ORiNOCO AP-2000 Troubleshooting Manual page 25

4. Enter the password (default is "public"). Result: The terminal displays a
welcome message and then the CLI Prompt:
[Device name]>
5. Enter
show ip
[Device name]> show ip
IP Address: 10.0.0.1
Subnet Mask: 255.0.0.0
Default Router: 10.0.0.1
Default TTL: 64
Address Type: 1
6. Change the IP Address and other network values using set and reboot
CLI commands, similar to the example dialog below (use your own IP
Address and Subnet Mask). Result: After each entry the CLI reminds you
to reboot; however wait to reboot until all commands have been entered.
[Device name]> set ipaddrtype static
[Device name]> set ipaddr <IP Address>
[Device name]> set ipsubmask <Subnet Mask>
[Device name]> set ipgw <Default Gateway IP Address>
[Device name]> reboot 0
7. After the AP-2000 reboots, verify the new IP Address by reconnecting,
and then entering a show ip CLI statement (as in Step 5). Alternatively,
you can use the ping network command from networked computers to
test the new IP Address.
8. When the proper IP Address is set, use CLI or the HTTP Interface over
the LAN to complete configuration and manage operations.
. Result: Network parameters appear:
Reset and Reload Procedures
25