Forced Reload Procedure - ORiNOCO AP-2000 Troubleshooting Manual

Forced Reload procedure

Use this procedure to force the AP-2000 back to default network
configuration values and download a new AP Image. This procedure may be
required when the password is forgotten or the current AP Image is missing
or corrupted.
In this procedure, use the Bootloader CLI over the serial port to set the IP
Address and download a new AP Image.
1. While the AP Image is running, press the RESET button. Result: The
AP-2000 reboots and the indicators begin to flash.
NOTE:
By completing Step 2, the firmware in the Agere AP-2000 will be
erased. A serial cable will be required to reload firmware.
2. Press and hold the RELOAD button for about 20 seconds until the
POWER LED turns amber. Result: The AP-2000 deletes the current AP
Image and Configuration files. The Bootloader CLI becomes active. The
following procedure describes how to use the Bootloader CLI to assign
an IP Address and download a new AP Image.
Reset and Reload Procedures
19