Setting Ip Address Using Serial Port And Normal Cli - ORiNOCO AP-2000 Troubleshooting Manual

Setting IP Address using serial port and normal CLI

Use the following procedure to set an IP Address over the serial port using
the normal CLI. The network administrator typically provides the AP-2000 IP
Address.
Hardware and software requirements
Standard serial data (RS-232) cable with a male DB-9 connector on one
end and a female DB-9 connector on the other end.
Serial Port Adapter plug to convert DB-9 to Mini-DIN8 (supplied with kit).
ASCII Terminal software, such as HyperTerminal.
Attaching the serial port cable
1. Remove power from the AP-2000 and your computer.
2. Connect the male end of the serial port cable to the Serial Port Adapter,
and then plug the Serial Port Adapter into the Mini-DIN8 connector on
the back of the AP-2000.
3. Connect the female end of the serial port cable to the computer.
4. Restart the computer and power up the AP-2000.
Reset and Reload Procedures
23