Device Installation
4.1 Installation Procedure
This section describes the steps to install and mount the device(s).
: The device must be installed by a trained professional who is familiar with radio frequency planning and
regulatory limits. Please refer
Perform the following steps to install and mount the device
Step 1: Plan for Installation
There are several planning factors to be considered before installing the device. In addition to selecting the installation site,
you should do the following:
Determine:
•
System frequency plan
•
Required antenna mounting height to obtain proper path clearance
•
Required transmission line types (like RF cable, waveguides) and lengths
Plan for:
•
Device's continuous power consumption needs
•
Lightning protection and system grounding
•
Hardware mounting
•
Cable installation including ingress
•
Pre-testing equipment (back-to-back test)
Step 2: Choose a Location
To make optimal use of the device, you must find a suitable location to install the hardware. The range of the radio device
largely depends upon the position of the antenna. Proxim recommends you do a site survey, observing the following
requirements, before mounting the hardware.
•
The location must allow easy disconnection of power to the radio, if necessary.
•
Ensure free flow of air around the hardware.
•
The radio device must be kept away from vibration and excessive heat.
•
The installation must conform to local regulations at all times. For details, please refer to
Information.
The devices are designed to directly mount to a pole. By using the supplied brackets and hardware, you can mount them to
a 1.5 to 3.25 inch pole (outside diameter).
®
ORiNOCO
AP-9200R - Hardware Installation Guide
Safety & Regulatory Information
for details.
Safety & Regulatory
4
10