Control-Signal Enable/Disable Switches (S4); Low (0)/High (1) Switches (S3) - Renesas HS0008EASF5HE User Manual

Flash microcomputer on-board programming adapter board

Table of Contents

3.2.5

Control-Signal Enable/Disable Switches (S4)

This adapter board is provided with switches so that each control signal can be enabled or

disabled separately, as shown in table 3.2; the control-signal switches that are necessary to

program the

flash microcomputer should be set to E. These switches are inside the case. Open the upper panel

by removing the screw in each corner between the upper and lower panels. After switch setting,

reclose the case and refasten the screws.

Table 3.2

Control-Signal Enable/Disable Switches (S4)

Signal

FWE (S4-1)

MD0 (S4-2)

MD1 (S4-3)

IO0 (S4-4)

IO1 (S4-5)

IO2 (S4-6)

3.2.6

Level 0 or 1 can be selected by enabling the enable/disable switch (S4) (see table 3.2). Select 0 or

1 for the control signals according to the flash microcomputer you are using (to program the flash

microcomputer). Also, S3-8 (the RES output selection switch) can switch the control sequence at

the time of programming regardless of the setting of S4, so that the level output by the RES pin

after power has been supplied or operation in a mode has been terminated can be selected.

These switches are inside the case. Open the upper panel by removing the screw in each corner

between the upper and lower panels. After switch setting, reclose the case and refasten the

screws.

Enabled

Section 3 Connectors, Switches, and LEDs

Disabled

Rev. 1.00 Oct. 02, 2009 Page 13 of 22

REJ10J2064-0100

Table of Contents