Table of Contents
Advertisement
Observe the precautions listed below. Failure to do so will
result in a FIRE HAZARD and will damage the user system and
the adapter board or will result in PERSONAL INJURY.
The USER PROGRAM will be LOST.
1. Always switch OFF the adapter board and user system before
connecting or disconnecting any CABLES, PARTS, or cable
head.
2. Before connecting, always make sure that pin 1 on both sides
are correctly aligned.
3. The adapter board can be used for flash microcomputers
to which Vcc = 2.7 V to 5.25 V, PVcc = 2.7 V to 5.25 V is
supplied from a single power source.
The adapter board cannot be used for flash microcomputers
in which 12 V is applied to both the Vpp pin and MD pin.
The values of Vcc and PVcc must not exceed the guaranteed
operation ranges.
Rev. 1.00 Oct. 02, 2009 Page viii of x
REJ10J2064-0100
WARNING
Advertisement
Table of Contents
