Section 3 Connectors, Switches, And Leds; Connectors; User Interface Connector (P1) - Renesas HS0008EASF5HE User Manual

Section 3 Connectors, Switches, and LEDs

3.1

Connectors

This adapter board has connectors P1, P2, and P3.
3.1.1

User Interface Connector (P1)

Observe the precautions listed below. Failure to do so
will result in a FIRE HAZARD and will damage the user
system and the adapter board or will result in PERSONAL
INJURY.
1. Always switch OFF the adapter board and the user
system before connecting or disconnecting ANY
CABLES
or PARTS.
2. Before connecting, always make sure that pin 1 on both
sides are correctly aligned.
3. When disconnecting cables, take care not to put
excessive stress on the cables.
The signals required for writing to flash memory are shown in figures 3.1 and 3.2. Connect the
adapter board and the user system using the user system interface cable provided (with an 20-pole
connector on each end) and a user system interface cable connector (used for connecting the cable
to the user system). The user system interface cable provided straight-matches the pins in the
adapter board to those in the user system, as shown in figure 3.2.
A 3428-6002LCPL manufactured by Sumitomo 3M Ltd. (former part code: 3428-6002 LCSC) is
used as the user-system interface cable connector.
WARNING
Section 3 Connectors, Switches, and LEDs
Rev. 1.00 Oct. 02, 2009 Page 5 of 22
REJ10J2064-0100