Jumper Terminals For Power-Supply Switch (Jp1) - Renesas HS0008EASF5HE User Manual

3.2.3

Jumper Terminals for Power-Supply Switch (JP1)

The jumper terminals are inside the chassis. Open the upper panel by removing the screw in each
corner attaching the upper and lower panels. After jumper setting, close the chassis by re-fixing
the screws.
The following two methods are available for supplying power to the adapter board; appropriate
jumper setting is required for these jumper terminals.
• To supply power from the user system via the user system interface cable connector (VIN
pin), insert a jumper into 2 and 3.
• To supply power from power-supply connector (P3), prepare a power supply for the adapter
board. Insert a jumper into 1 and 2 (default setting at shipment).
Figure 3.4 Jumper Terminals for Power-Supply Switch (JP1)
Figure 3.3 Power-Supply Switch (POWER)
JP1
1
2
3
Section 3 Connectors, Switches, and LEDs
On
Off
Jumper
Rev. 1.00 Oct. 02, 2009 Page 11 of 22
REJ10J2064-0100