Table of Contents
Advertisement
37. Plug each power cord into the input power connections on the rear of the
38. Install the power modules at the front of the unit (see "Installing a power
39. Install the blade servers (see "Removing and installing a blade server or filler
40. Install the I/O modules (see "Removing and installing I/O modules" on page
41. Start the system (see "Starting the BladeCenter T unit" on page 16).
Removing and installing the optical drive
Use the instructions in this section to remove or install the optical drive in the
media tray. See "Media tray" on page 9 for information about the system-status
panel controls and indicators.
Removing the optical drive
Complete the following steps to remove the optical drive from the media tray:
1. Remove the media tray from the BladeCenter chassis (see "Removing the
2. Remove the screws that secure the media-tray front panel and optical drive
3. Carefully lift and slide the optical drive cage off of the media-tray base.
4. Turn over the optical drive cage and disconnect the optical drive power and
5. Disconnect the optical drive cable from the connector on the rear of the optical
6. Remove the wire retention spring.
7. Slide the optical drive out of the drive bay.
78
BladeCenter T Type 8267: Hardware Maintenance Manual and Troubleshooting Guide
BladeCenter T unit. See "Starting the BladeCenter T unit" on page 16).
module" on page 45).
module" on page 60).
56).
media tray" on page 47 for more information).
cage to the media-tray base.
signal cables from the connectors on the media-tray board.
drive.
Advertisement
Table of Contents
