Table of Contents
Advertisement
v Read "Handling static-sensitive devices" on page 37.
1. Shut down and remove power from the system (see "Shutting down the
BladeCenter T unit" on page 17).
2. Remove each power cord from the input power connections on the rear of the
BladeCenter T unit.
3. Remove the power modules from the bays at the front of the unit.
Note: The power modules dock into the docking board on the assembly and
must be removed before you can remove the assembly.
4. Remove the KVM module from the rear of the system (see "Removing the
KVM module" on page 54).
5. Remove the LAN module from the rear of the system (see "Removing the
LAN module" on page 55).
6. Remove all I/O switches and switch fillers from the rear of the unit.
7. Remove the ac rear panel from the rear of the unit (see "Rear panel" on page
63).
8. Remove the two upper flex circuit assemblies (see "Upper flex circuit
assembly" on page 64) and the two lower flex circuit assemblies (see "Lower
flex circuit assembly" on page 66).
9. Loosen the four captive fasteners on the old rear chassis stiffener bracket.
10. Pull the old rear chassis stiffener bracket off the chassis.
11. Remove the new rear chassis stiffener bracket from its packaging.
12. Align the stiffener bracket with the "Up" arrow pointing upwards.
13. Position the bracket on the chassis, and tighten the four captive fasteners.
14. If you have no other replacement procedures to perform at the rear of the
system:
Chassis stiffener bracket
U P
Captive fastener (4)
Chapter 5. Service replaceable units
U P
69
Advertisement
Table of Contents
